![]() LAN 1 - BACnet Port - can be configured by the user to have a dynamic IP address or a user defined static IP address.The CopperCube comes pre-configured with two active Ethernet ports: The Time Zone and Header Logo settings are one that are recommended to be updated. The Basic Settings page is used to do some configuration of the CopperCube. Below are the steps for configuring your CopperCube: You have to configure the CopperCube so that it can start sending data to the secure cloud. If you are logging into the CopperCube for the first time, see the image below for username and password. The CopperCube GUI requires the user to log in using a username and password. If the setup is correct, you should see the status page of the CopperCube graphical user interface (UI). Open a web browser and enter 169.254.8.29 into the address bar.Please note that the CopperCubes purchased prior to Mahas a different fixed-IP. Plug a Cat5e cable into your computer's network port and then into and into the CopperCube fixed-IP Service port (labelled LAN 2).When the CopperCube starts up, it will produce a short beep. ![]() Check the Power LED and if it is not on, press and hold the power button until the green power light turns on.Part numbers are 194300 (North America) and 194301 (European) If you did not order a power supply and require one, they are available through online ordering. Connect 24VAC/50VA to the 2-pin screw terminal or 12-28VDC/30W through the barrel connector of a power supply to the CopperCube.This document describes the steps that need to be done in order to set up your CopperCube so that it can collect data from your BACnet network. Your CopperCube has come from the factory in an unconfigured state.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |